![]() Turns out, all my kicking and screaming was a waste of energy, because the end result looked almost exactly what I had envisioned (minus the furniture and waterfall). We stood back to take a look, and I’ll be damned! After only a little bit of adjusting, which we did by moving the screws holding the chains a hair up or down, the panels were level and evenly spaced. ![]() He then attached an S-hook into the bottom link, and squeezed the link back together with his pliers.įinally, we hooked the S-hooks that were attached to the end of the chains, into the eyescrews on the top of the frames, and hung the panels. Using two needle-nosed pliers, he opened the last link on the chain and slipped off the excess chain. He measured the chain from the drilled screw to the length we needed to attach it to the panel for the height we had decided on. We used 10 lb capacity chain (that I was certain wasn’t strong enough to hold the panels). ![]() Starting at one end, Paul slipped the drill bit through the chain, attached a screw to the drill bit (I love that they’re magnetic), and drilled the screw at his first mark. Then we measured and marked to be sure the three panels were evenly spaced across. Paul held up a panel while I eyeballed the height (very high-tech precise measuring system, yes?). I wanted the panels to be placed at a height that provided privacy both when we were sitting or standing. We then screwed eyescrews into the starter holes. Next, we hauled the panels to the patio (notice that I said we?), and drilled starter holes in the center of both end boards on each panel. (At this point we had begun speaking again). We quickly finished the other two panels, and the construction phase was done. It turned out a lot sturdier than I thought it would be. We did a final check to make sure everything was square, then air stapled the end of each lattice slat to the frame. When the boards were dry, we laid them out, squared the corners, and glued the frame corners with wood glue. If it looked tacky like that, we’d add a frame to the back. I wanted to sandwich the lattice between two frames, but we were out of lumber, so I agreed to seeing how it looked with the frame on just one side. I made sure to paint the ends of the boards since some of the ends would be exposed. Paul took a break while I painted all the boards with a couple coats of white exterior paint. Instead of mitering the corners, we decided to straight cut the boards and just butt the corners together. Our lattice panels measured about 32 x 48, so Paul cut enough 1 x 3’s to create frames for each. We had some 1×3 boards left over from a previous project, and a half can of white paint in the basement, so all we needed to buy was a bit of hardware and we were good to go. ![]() Cheeeaap! I wanted to keep the lattice it’s natural wood color, but I wanted to paint the frame white. The week before, we had picked up three lattice panels at an estate sale for like $5 total. He patiently waited while I threw a small fit and allowed a sufficient amount of time for pouting before we got to work. Why can’t we have full growth ivy winding it’s way through the lattice panels, while we sit in cushy new patio chairs sipping Mojitos listening to the gentle gurgle of a three-tier water feature? Asshole! I’m happy to report that we’re still married, considering our…”lively” discussion during which he informed me he couldn’t make my champagne vision work on my beer budget. Paul (the hubs), was going to be doing most of the work, and I would be the job foreman. I’ve seen several DIY projects for privacy fences, but I didn’t want to spend a lot of money or put a ton of effort into this project. I feel so exposed! Even though we don’t spend a lot of time on the downstairs patio, when we do, I want privacy! When we do spend time on the patio, we have the houses across the street looking down on us from their decks. We spend most of our time on our upper deck, but occasionally entertain on the patio below. Our house is built on a slope which gives us a front entrance at street level, but a totally daylight lower level. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |